Loading... Please wait...

Our Newsletter

Single Portable Heat-troller Coax

  • Image 1
Calculated at checkout

Product Description

Single Portable Heat-troller Coax Comes with battery harness with covered fuse holder
Recommended for All Heated Clothing

Electronic, solid state design coupled with analog control for a full range of heat, with minimum power loss
LED provides visual feedback for On, Off, Power Level & Polarity
Sealed Switch with tactile On/Off with 300° rotation, providing heat from 3% to full on!
Heat-troller is waterproof and can be left on the bike in the rain
Solid State, High Tech, Safe & Reliable Electronics designed by us
Fits comfortably into the palm of the hand or pocket or on the Bike or Scooter or Horse or Small Airplane or just about anywhere!
Battery harness made of automotive grade wire that is resistant to oil,  acid, water and grime with automotive style fuse
Handles 15 amps at 13 volts with internal reset for  overloads & shorts & works from 7 volt to 24 volt

Find Similar Products by Category

Write your own product review

Product Reviews

Showing reviews 1-5 of 10 | Next

  1. Keeping my TourMaster Jacket 5 Star Review

    Posted by on 4th Jun 2015

    After the original heat controller broke for my TourMaster jacket I was at odds at what to replace it with. Thanks to Warm & Safe I am able to keep my TourMaster heated jacket and keep toasty warm. The controller is easy to install,and can be operated with gloves as well.
    Be sure to order the controller pouch as this little unit will make it easy to mount your controller anywhere.

  2. Great stuff! 5 Star Review

    Posted by on 1st May 2015

    I live in Alaska and heated gear is a must for almost all the riding season. Warm N Safe is the best! I only go to one site to find what I need.

  3. A quility made item! 5 Star Review

    Posted by on 11th Apr 2015

    After going through three replacement controllers for my Synergy vest and jacket I had just about given up on them. Then I came across the warm&safe line of products. I ordered the single control unit and it arrived in just a few days. I have used it on my morning rides to work and could not be more pleased. It works just as it should and seems to be very well constructed of quality components. I am expecting years of good service from it and am already looking forward to trying out some other warm&safe products in the near future. Nice job folks! Thanks!

  4. Easy to install 5 Star Review

    Posted by on 18th Nov 2014

    Super easy to set up and easy to take with you after your ride. Just don't forget to also buy the Y splitter!

  5. Don't leave home without this! 5 Star Review

    Posted by on 30th Apr 2014

    I've used heated gear for about 20 years and finally got a HeatTroller to use with my new W&S 90W Gen4 liner. It's a combination made in riding heaven!

    The HT allows very precise regulation of the considerable heat potential of the the 90W liner; in fact, the liner gets so hot on high that I think it would be unusable with the HT.

    The HT's knob is about as small as it can be and still be useable with gloves. I'd prefer a bit more resistance or "feel" to the knob to make adjusting it with heavier gloves easier but it works well and holds its position. If you do bump it, you'll know very quickly as you'll either be too chilly or too hot in short order.

    It took some time to figure out how to deal with all the wires involved with the Heat Troller but with a bit of planning, two wire ties and the velcro included in the package, I ended up with a very neat installation on my R1200RT that I can move to another bike in seconds. (I chose the portable unit because I try to avoid drilling holes in expensive fairing panels if I can avoid it.)

Showing reviews 1-5 of 10 | Next