Symtec Heated Grips Wiring Instructions

NOTES: The drawing shows how to hook up the grips.

Wire the two red wires coming off of the Symtec Heated Grips together and wire the two white wires coming off of the Symtec Heated Grips together so that you end up with two wires: 1) Red with Red. 2) White with White. Then the White goes to White on the Heat-troller and the Reds go to the Purple on the Heat-troller.
You will not wire up the two Blue wires to anything. Not even to each other! The heat-troller provides the ground circuit. Tape the Blue wires off individually so they ARE NOT connected together and do not short out.

If you are going to use a relay, on a 5 pin relay, ingore pin 87A